Re: Open Door by pressing the answer button of an ip phone
Does the door open automatically when the call is answered? Is the device off the FXS port smart enough to notice when the call is connected, that the door should be opened? Or does a code need to be sent to the device after connect?
Note that without getting super fancy, the 'answer' button on the phone will only always do just that--answer an inbound call that is presented to it.
You assign an extension to an analog phone in CME in one of two ways. The first is a simplier config, and will work just fine for you, I think.
* Non SCCP controlled (FXS port will not have supplmentary services):
dial-peer voice 23 pots
* SCCP controlled (conference/hold/transfer/hookflash features supported):
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.