Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

outbound caller id on CME 4.1

How can I get the full 10-digit originating number to show up during outbound calls? Right now, the dialed number on PSTN side gets the 4-digit extension.

This should be an easy one -- I've done this many times on CCM, 1st on CCME.

Thanks,

Jad

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: outbound caller id on CME 4.1

There is more than one way. One is "dialplan-pattern 1 555123.... extension-length 4"

Hope this helps, please rate post if it does!

7 REPLIES
Hall of Fame Super Gold

Re: outbound caller id on CME 4.1

There is more than one way. One is "dialplan-pattern 1 555123.... extension-length 4"

Hope this helps, please rate post if it does!

New Member

Re: outbound caller id on CME 4.1

beautiful - worked like a charm.

Hall of Fame Super Gold

Re: outbound caller id on CME 4.1

Great. For your information, you're one of the few users in the world allowed to send arbitrary numbers as caller-id. Use that wisely and don't pretend to be someone else, like the White House calling :)

Thanks for the nice rating and good luck!

New Member

Re: outbound caller id on CME 4.1

Nice to know :)

I ran into another problem - once I added the dialplan, calls stopped forwarding to voicemail after 3 rings...it would just go to busy. Removing it fixed the problem, but now i'm back to square one. How can I get both to play nice together?

Hall of Fame Super Gold

Re: outbound caller id on CME 4.1

The thing is likely now, calls going to VM are sent with the full calling number too.

Check debug ccsip message to confirm.

I think something can be done in the VM to accept these numbers as alias of the extension only, if not, there is a simple translation rule you can use instead

voice translation-profile make10

translate calling 10

voice translation-rule 10

rule 1 // /555123/

voice port x/y:23

translation-profile outgoing make10

New Member

Re: outbound caller id on CME 4.1

Thanks again! That translation rule did the job just fine. I wasn't sure about the VM aliases, so didn't mess with that.

Jad

Hall of Fame Super Gold

Re: outbound caller id on CME 4.1

You are very welcome. Now the next part is when your customer will ask that certain extension present DID, others present pilot, and others again present "private" :)

Worry not we'll be here to answer that as well.

150
Views
0
Helpful
7
Replies