Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Outbound calls receive silence after dialing number

Hello,

I have an issue where users at a site are trying to place outbound calls to the PSTN but are unable to.  They receive a dial tone and dial the numbers but receive nothing but silence after dialing the number.  Even after 2 minutes there is still only silence.  I have attached debugs for ccapi inout, vpm signal and h225 ans1.  Any help or troubleshooting ideas would be appreciated

Call Flow:

IPhone -> CUCM -> H.323 -> Gateway -> PSTN

 

Thank you,

Preston Hartley

1 REPLY
Green

Preston,Looks like the call

Preston,

Looks like the call is trying to go out on voice-port 1/0/15 (FXO)


Have you proved that you can make calls on the line attached to router
by disconnecting router and use a POTS phone.

debug vpm signal - may also help.

Also this link may help too.
http://www.cisco.com/c/en/us/support/docs/voice/h323/14081-voip-debugcalls.html

Hope this helps
Regards
Alex

Regards, Alex. Please rate useful posts.
104
Views
0
Helpful
1
Replies
CreatePlease login to create content