Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Outbound dial peer not working

Here is my dial peer config

dial-peer voice 5 pots

description T1-CAS

service mgcpapp

direct-inward-dial

port 0/2/0:1

!

dial-peer voice 6 voip

destination-pattern ....

session target ipv4:10.192.9.253

dtmf-relay h245-alphanumeric

a debug shows that I am matching the inbound dial peer 5, but then I get a dial tone and fast busy on the phone. Any thoughts

thanks for your help

3 REPLIES
Community Member

Re: Outbound dial peer not working

Is this supposed to be an H323 dial peer? What are you trying to accomplish?

-Shikamaru

Community Member

Re: Outbound dial peer not working

No, it is an MGCP GW servicing 15 DID's with a 5 channel T1-CAS line.

Community Member

Re: Outbound dial peer not working

You should not be manually configuring dial peers on an MGCP gateway unless you're setting up SRST. In fact, that's kind of the point of using MGCP to begin with; it configures dial peers for you when you set up the gateway in CallManager. Your MGCP dial peer will literally look like this when CM sets it up for you;

dial-peer voice 999100 pots

application mgcpapp

port 1/0/0

!

dial-peer voice 999101 pots

application mgcpapp

port 1/0/1

Do NOT try to set up the above example manually, it will not work. Brush up on MGCP, it's easier than you're letting it be.

-Shikamaru

147
Views
0
Helpful
3
Replies
CreatePlease to create content