Tested this gateway before we deployed it in another town and have run into a problem One problem was inbound dialing which I corrected by battery-reversal on the FXO ports. I still have problem outbound though. I see the port go off-hook for a second and then back on-hook. Get a fast busy on the call. It appears to be hitting the right dial-peer in the ccapi debug but when I do a debug dialpeer I don't see anything. Like I said, it worked perfectly at the corporate office while testing. Not sure where else to look. Any ideas???
Here is the debug ccapi. Dialed number is 9 9857916891
Aug 20 21:29:23.855: //-1/801D293F0D00/CCAPI/cc_api_display_ie_subfields:
----- ccCallInfo IE subfields -----
cisco-redirectreason=-1 fwd_final_type =0
Aug 20 21:29:23.859: //-1/801D293F0D00/CCAPI/cc_api_call_setup_ind_common:
Battery reversal fixed inbound calling? Makes me start to think you might be hitting a ground start circuit but your debugs are showing it as loop start. Try switching the signaling and see if that helps. Make sure you do a shut no shut on the voice port for the change to take place.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...