Can someone please advise the command to send a call to an FXO port after a certain number of digits have been received (can be any 8 digits)? Currently I wait 10 or so seconds after entering my last digit until I hear an outbound ringtone (PSTN connection), the phone will just hang for 10 seconds. Secondary Dialtone is set at 9, current config below:
dial-peer voice 1 pots
description FXO Outbound 1
All I basically need to do is have 8 digits sent immediately to the PSTN after dialing 9 for an outbound access code first.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...