Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Outbound number identification - CME 7.1

I have and issue that the outbound calling info is incorrect from the 2811 CME box. We currently have a PRI terminated into this box and would like to change the number being sent/displayed on outbound calls to external cell phones/devices. Any idea how I do this?

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Outbound number identification - CME 7.1

If you want to have the same number for all outgoing calls then you can add "isdn calling-number xxx-xxx-xxxx" to your serial interface as shown below.  If you want everyone's DID to go out as there own number then you will need to create translation's on your gateway to do acheive this.

interface Serial6/0:23

no ip address

no logging event link-status

isdn switch-type primary-ni

isdn incoming-voice voice

isdn calling-number xxx-xxx-xxxx

no cdp enable

HTH, Please rate if so.

Regards,

Justin

Re: Outbound number identification - CME 7.1

If using translation rules to mask everyone to the same number:

!

voice translation-rule 1

rule 1 /.*/ /3305551212/

!

!

voice translation-profile CALLERID

translate calling 1

!

!

dial-peer voice 10 pots

translation-profile outgoing CALLERID

destination-pattern 81[2-9].........

port 1/0/0:23

forward-digits 11

!

5 REPLIES

Re: Outbound number identification - CME 7.1

If you want to have the same number for all outgoing calls then you can add "isdn calling-number xxx-xxx-xxxx" to your serial interface as shown below.  If you want everyone's DID to go out as there own number then you will need to create translation's on your gateway to do acheive this.

interface Serial6/0:23

no ip address

no logging event link-status

isdn switch-type primary-ni

isdn incoming-voice voice

isdn calling-number xxx-xxx-xxxx

no cdp enable

HTH, Please rate if so.

Regards,

Justin

Re: Outbound number identification - CME 7.1

If using translation rules to mask everyone to the same number:

!

voice translation-rule 1

rule 1 /.*/ /3305551212/

!

!

voice translation-profile CALLERID

translate calling 1

!

!

dial-peer voice 10 pots

translation-profile outgoing CALLERID

destination-pattern 81[2-9].........

port 1/0/0:23

forward-digits 11

!

New Member

Re: Outbound number identification - CME 7.1

Thank you. This worked perfectly.

Hall of Fame Super Gold

Re: Outbound number identification - CME 7.1

How the current number is incorrect, and what number you want to display instead ?

New Member

Re: Outbound number identification - CME 7.1

Thank you. The above suggestions worked for me.

212
Views
5
Helpful
5
Replies