Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Outgoing Call Routing

Hi team,

I have a UC560 with 12 FXO lines. How can I route outgoing calls based on the source.

     eg:

          - extension 100 to 105 should always go via FXO port 1

          - extension 106 to 110 should always go via FXO port 2

Nuwan

3 REPLIES
Green

Outgoing Call Routing

Hi,

You will need to configure Class Of Restriction

COR

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeblock.html#wp1022877

Hth

Alex

Regards, Alex. Please rate useful posts.
Community Member

Outgoing Call Routing

Hi Alex,

Thanks for your response. Can I do this using CCA 3.1?

Nuwan

Green

Re: Outgoing Call Routing

Hi,

I have had a search for configuring CoR via CCA but I can not find very much

I dont use CCA in my day job so if it was me I would need

to use cli.

I am including another link which gives a good explanation of CoR.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a008019d649.shtml

You could also try asking your CCA question under the "small business forum" where I am sure

you will obtain further help.

https://supportforums.cisco.com/community/netpro/small-business

HTH

Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
338
Views
0
Helpful
3
Replies
CreatePlease to create content