Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Outgoing calls issue

*Jun 27 10:19:53.715: ISDN BR0/1/0 Q931: Applying typeplan for sw-type 0x1 is 0x0 0x0, Calling num 0113252322

*Jun 27 10:19:53.719: ISDN BR0/1/0 Q931: Applying typeplan for sw-type 0x1 is 0x0 0x0, Called num 0119129300

*Jun 27 10:19:53.747: %ISDN-6-LAYER2UP: Layer 2 for Interface BR0/1/0, TEI 73 changed to up

*Jun 27 10:19:53.747: ISDN BR0/1/0 Q931: TX -> SETUP pd = 8 callref = 0x13

Bearer Capability i = 0x8090A2

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0x81

Calling Party Number i = 0x0080, '0113252322'

Plan:Unknown, Type:Unknown

*Jun 27 10:19:53.851: ISDN BR0/1/0 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x93

Cause i = 0x82C1 - Bearer capability not implemented

Any ideas? Let me know if you want the config, thanks

5 REPLIES
Cisco Employee

Re: Outgoing calls issue

The problem is due to this -

Bearer Capability i = 0x8090A2

This means the call is using ulaw coding and I would guess you are not located in North America.

Add the following command under voice-port 0/1/0

compand-type a-law

I would also suggest you add the following commands (in case you don't already have them) to ensure the DSP's are clocked off the BRI port -

network-clock-participate wic 0

network-clock-select 1 bri 0/1/0

This will fix faxing or modem issues that you may never know you had :-)

Re: Outgoing calls issue

that's a good one!

Chad

Hall of Fame Super Gold

Re: Outgoing calls issue

Missed this one .. 5 points to Paul for combining two all-time favorites in a single answer :)

New Member

Re: Outgoing calls issue

Yeah! Thanks okes, umm... 5 to you! Thanks, am going to test now. Will post results...

New Member

Re: Outgoing calls issue

Yip, executed the changes and also had to put the progree indicator and progress alerting on, am now able to make outgoing calls, however need to implement CoR now :)

306
Views
25
Helpful
5
Replies