Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

outgoing calls not working

Hello All,

Unable to make outgoing calls via voice gateway incoming calls working fine ..

outgoing calls are getting disconnected with message :

    Cause i = 0x80AF - Resource unavailable, unspecified

I have attached the debugs for outgoing calls. Can anyone please help

Thank you

Anil Sharma.

4 REPLIES
New Member

outgoing calls not working

Typically this error is B-Channel allocation for an outbound call. I see that you are sending and receiving call starting on the same ports. Can you switch the serial port channel selection for outbound to from desending to assending? That way the outbound will allocate in the opposite direction.

int ser x/x:15

isdn bchan-number-order ascending / decending

Other causes the Carrier is not accepting call for some reason. Try moving isdn call type and plan to unknown. It is National / unknown now.

mike

New Member

outgoing calls not working

Thanks for the reply Mike ..

Sorry I should have mentioned it , we have 2 voice gateways at site.

Primary voice gateway with same config is working fine for both incoming and outgoing calls.

This is the secondary Voice gateway from which outgoing calls are not working. Any ideas ?

Many Thanks

Anil Sharma

New Member

outgoing calls not working

Is this MGCP or H323?

I am still thinking this is a B-channel allocation issue. Can you change the channel selection.

DSP should not be an issue because you see call inbound get Bchannel allocation.

New Member

outgoing calls not working

Its H.323 gateway !!

716
Views
0
Helpful
4
Replies