Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

outgoing calls not working

Dears,

 

any one can help me in the following outgoing calls not working for the config , incoming is working , but outgoing not working

we ordered the following, we installed the CME 8.0

 

CISCO2901-V/K9

Cisco 2901 Voice Bundle  PVDM3-16  UC License PAK  FL-CUBE10

FL-CME-SRST-5

Communication Manager Express or SRST - 5 seat license

VIC2-4FXO

Four-port Voice Interface Card - FXO (Universal)

ISM-SRE-300-K9

Internal Services Module (ISM) with Services Ready Engine

FL-CUE-MBX-5

Unity Express License - 5 Mailbox - CUCM and CUCME

2 ACCEPTED SOLUTIONS

Accepted Solutions

For the given number,

For the given number,

the dial-peer will match is:

dial-peer voice 1001 pots
 corlist outgoing localcalls
 description "Local Calls"
 preference 1
 destination-pattern 9[1-8][^0][^0]....
 port 0/0/1
 forward-digits 7
 no sip-register

 

and it will match the port 0/0/1, but port 0/0/1 doesnt looks to be configured to me.

voice-port 0/0/1

can you configure the port, or try changing dial-peer to point to port 0/0/0

 

regards

Chintan

 

HelloTry to use port 0/0/0

Hello

Try to use port 0/0/0 instead of 0/0/1 because your configuration is under port 0/0/0 and for sure you do not have any circuit connect to 0/0/1 as the below:-

dial-peer voice 1001 pots
 corlist outgoing localcalls
 description "Local Calls"
 preference 1
 destination-pattern 9[1-8][^0][^0]....
 port 0/0/0
 forward-digits 7

Thanks

please rate all useful information

4 REPLIES

Hi, please give some more

Hi,

 

please give some more information on what number you are dialing and from what number your are dialing?

 

regards

Chintan

Community Member

hi trying to call outside

hi

 

trying to call outside local numbers

 

9 4163997

 

For the given number,

For the given number,

the dial-peer will match is:

dial-peer voice 1001 pots
 corlist outgoing localcalls
 description "Local Calls"
 preference 1
 destination-pattern 9[1-8][^0][^0]....
 port 0/0/1
 forward-digits 7
 no sip-register

 

and it will match the port 0/0/1, but port 0/0/1 doesnt looks to be configured to me.

voice-port 0/0/1

can you configure the port, or try changing dial-peer to point to port 0/0/0

 

regards

Chintan

 

HelloTry to use port 0/0/0

Hello

Try to use port 0/0/0 instead of 0/0/1 because your configuration is under port 0/0/0 and for sure you do not have any circuit connect to 0/0/1 as the below:-

dial-peer voice 1001 pots
 corlist outgoing localcalls
 description "Local Calls"
 preference 1
 destination-pattern 9[1-8][^0][^0]....
 port 0/0/0
 forward-digits 7

Thanks

please rate all useful information

577
Views
10
Helpful
4
Replies
CreatePlease to create content