I have voice gateway where ISDN is terminated. Incoming DID is OK since i gave secondary command under each ephone-dn (like number 1234 secondary 7831234) but when i dial outside (to pstn), only main number of ISDN is being displayed.
Please post "debug isdn q931", probably what is happening is telco is overwriting your number with the BTN number either because your number is not formatted properly or because that's the way the circuit was ordered. We can see what is happening from the debug. Identify what you are seeing and what you expect to see.
You will need to configure voice translation rules to map your internal extensions to your DDI range for your provider to display it. When you place a call to most PSTN providers and the calling number shows as internal number, they will replace it with the Mian number i n your DDI range. So you need to create xlation rules to change your internal DDI range to your block of DDIs
Please rate useful posts
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...