Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

outside dial is not passing.

Hi,

I am using CUCM 8.6, provideding 71XXX series extension to my customers,My dial pattern for out side is 9.[256]XXXXXX to access outside call through my nortel system.But the problem is now, nortel guy is planning to change the access code.He is telling that if i press "9" it use to access code"2906",now he is planning to change into "3706".Also he tested by changing 2906 to 3706,after that i can not dial outside by pressing "9".it gives message of "cannot be completed as dialed".So he return it back now.But i must do it next few days.

So,should i do any change/modify in route pattern in the CUCM.Where i can find this access code in CUCM.

Regards

AZ

1 REPLY
Hall of Fame Super Silver

Re: outside dial is not passing.

Prefix digits at the dial peer that nortel can route based on.

Sent from Cisco Technical Support iPhone App

98
Views
0
Helpful
1
Replies