Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Overhead Paging Cooper SP40s System - Connecting to FXO or FXS?

We have a site that just installed a Copper Industries SP40s paging system. (See link below)

http://www.cooperindustries.com/content/dam/public/safety/notification/Resources/Instruction%20Sheets/P84714.pdf

The information provided by the vendor is:

we need an "sa phaseport 600 ohm 1 volt peak to peak and if that is not available then we need a module to convert signal to line level"

I have a 2921 with FXO card as well as a VG204. I am trying to determine if either of these will work, or if I need an intermediary device. 

Any suggestion on how to configure this would be greatly appreciated. 

 

Everyone's tags (4)
1 REPLY
New Member

Anyone?

Anyone?

54
Views
0
Helpful
1
Replies