I am trying to connect my old Bogen V100 Amp with a Tel1s module in the back to my Cisco Voice gateway. I have wired it up and I tested the speakers are working. But when I call my overhead paging number I get nothing
Any idea is the module Bogen Tel1s can work with FXO card and what the jumper should be set to
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.