Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

overlay-dn configuration over two CME routers

I currently have CME 4.2 running at our headquarter location.  Because 4.2 does not support broadcast hunt groups, I have been using the overlay-dn method to have department extensions ring on multiple phones.  I am prepping for another office opening in another location in which I will be using CME 7.0 and a SIP trunk over a VPN.  I would like to avoid upgrading the headquarters router because it also is the gateway for an IPCC call center which was a bear to set up initially with CME.  Can anyone think of a way to have a department DN ring at both sites?  I know I could upgrade the headquarters CME to gain the use of broadcast hunt groups but again, I am looking to avoid that if possible.

Thanks in advanced.

Hall of Fame Super Gold

Re: overlay-dn configuration over two CME routers

If I was you, I would upgrade without a doubt.

Anyway, I wrote a TCL/IVR script that allows blast calling:

Or you can contact me at the address rpesent in my profile