Cisco Support Community
Community Member

Paging Configuration???

Hi Folks,

I have a 2811 router in production in a remote facility and have it configured with an external paging system (PA speakers and third party amplifier). the paging function is accessed by pressing '4' on any phone. I would like to change that so paging is accessed by pressing '4*' or '*4' to avoid telemarketers autodialers which occasionally access the paging system having their broadcast messages heard throughout the facility (very embarassing).

I have read through the CUE 2.3 Admin guide and have reviewed my config but for the life of me I cannot see where in my config '4' is specificed as my number to access paging.

Anyone one there know where I should be looking or what commands I need to set my paging number from '4' to '*4' or 4'*'??

Any help is always greatly appreciated!

Thanks in advance!


Re: Paging Configuration???

Here is the steps for paging configuration. It may help you

1. enable

2. configure terminal

3. ephone-dn paging-dn-tag

4. number number

5. name name

6. paging [ip multicast-address port udp-port-number]

7. end

For configuring the paging follwing URL may help you

CreatePlease to create content