Is there any way to limit the time a call to a paging dn will remain connected? I have problems will users not hanging up or accidentally putting on hold. I need to be able to disconnect calls to the paging dn after a minute or so.
How is the paging system connected to your call manager express? When you indecate straight voip is it that the paging system has a network connection that you use to access? "network would replace the e&m or fxo wic card" Im curious because I have to set up pageing for our stores and I havnt found a solution that allows me to have a pure network connection to an overhead paging amp. Any info is greatly appreciated.
We are using the paging feature of CME. Which means we have a full CUCM that connects H.323 to the CME. Then, when phones on the CUCM dial a RP that points to the CME we have phones setup that auto answer with the paging feature. Here is the config:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...