Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Paging to a SIP device

I need to page to a 2N SIP Speaker and several ephones all at once on a UC560 CME 8.6

I have the page group setup for the ephone and thats good to go.

I can't seem to get the 2N to register as a SIP device. I have it configured in the voice register dn and pool. Belows the SIP config I have. Please note that I do not have the Voice register pool 1 assigned a paging DN for testing.

voice register global

mode cme

source-address 192.168.0.25 port 5060

max-dn 5

max-pool 5

authenticate register

create profile sync 2444610541562842

!

voice register dn  1

number 890

name 890

no-reg

auto-answer

label Test

!

voice register pool  1

id mac 7C1E.B300.85D0

session-transport tcp

number 1 dn 1

dtmf-relay rtp-nte

no call-waiting

codec g711ulaw

With this setup, I am unable to dial 890 and get the SIP device. Any thoughts on why? As a side note, I can call the deivce just fine using a Dial-pper voip.

Thank you

Jason Ryan

1 REPLY
New Member

Paging to a SIP device

I was able to have the device register as SIP after some troubleshooting. It was all for not however since you cant put a SIP device in a Paging-DN on a SIP device in Cisco CME 8.6 like on a UC560.

229
Views
0
Helpful
1
Replies