Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Paging using FXO Ports

If the paging equipment can handle an FXO port is there any reason that we can not use the FXO port on the interface of a CUCME?

1 REPLY

Re: Paging using FXO Ports

Typically you would use FXS from CUCME to the paging system. However, i've seen valcoms use FXO and it should work...It all depends on the vendor requirements that you will be integrating with. So to answer your question yes.

262
Views
0
Helpful
1
Replies
CreatePlease to create content