Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Paging with Viking ZPI-4

I will be doing an IPT conversion that uses a Viking ZPI-4 paging interface. I'll be using an fxs port on the gateway for paging. The Viking manual is cryptic and there really isn't too many dip switches on it. I just wanted to see if someone could provide specifics about the hardstraps/config of the Viking before my cut-over, as I hate surprises and want to eliminate as many "known unknowns" as possible! Certainly, the fxs to the "paging in", but how about the "ring-trip/trunk" and "talk batt" switches? THANKS!

3 REPLIES
Hall of Fame Super Red

Re: Paging with Viking ZPI-4

Hi Michael,

Should be very straight forward :) Have a look at the Phone System Interface section of this good spec sheet;

http://assets.twacomm.com/assets/pdf/5318.pdf

Hope this helps!

Rob

New Member

Re: Paging with Viking ZPI-4

Rob,

I saw that, and like most pager manuals, is pretty much non-descript on what you would set the toggle switches for in order to connect to specific interfaces. I'd just like to hear from some one that I don't need anything special, or what settings I need for fxs so I don't run a problem at cut-over time that I could have prevented. Just me being paranoid doing customer cut-overs.

Hall of Fame Super Red

Re: Paging with Viking ZPI-4

Hi Michael,

I thought Page 4 was pretty good myself. For an FXS connection use the following Dip Switch settings;

1- On

2- Off

3- Off

4- Off

Take care,

Rob

360
Views
0
Helpful
3
Replies