When you change the partition name it is required to reset all associated devices. While doing this recently I also had it mess up some of the the TFTP loads, and I had to make a fake change through BAT to get CCM to update them fully. Very wild. I changed the internal partitions name on 3000 devices though, a bit extreme. Just be careful and test test test!!!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.