I have a number of cisco IP phones 7941, 9971 etc that I like to password protect to avoid unauthorised persons calling out on the phones. I have tried using the common phone profile under Device settings on CUCM 7.1.2 to no avail.
FAC has been sabotaged and found useless since FAC codes assigned could be used on another phones in the same Partition.
Please any solution is appreciated.
Also, is there a way I can use ACL on CUCM to avoid calls dialling after work hour except a specific password is supplied after a prompt on each phone.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...