Are you being asked for a username/password after "service-module service-enging 0/0 session"? If so, check the line for the CUE module. In your router config, along with "line vty 0 4", etc you will have something similar to "line 194". Is this line set to require a login? If so, remove the login command.
Are you trying to get to the CUE module CLI from the router? Are you being prompted for username/password after "service-module service-enging 0/0 session"? Is it prompting for username/password or just password?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...