Re: PBX extension (allow) and External Calls (block)
If you are using DID (Direct In Dial) for your inbound calling numbers then you can use any block of numbers that are non-DID for these "Internal Only" users. For example, if your DID range is XXX-XXX-2000 to 2299 (300 DID numbers) you could use 4000 to 4299 for these dummy DN's. They can still be called Internally but not from the PSTN.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...