Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PBX Ports going into a Port Trouble State

Have a 3845 router with VIC2-2E/M cards connected to Fujitsu 9600 PBX. Randomly the ports on the Fujitsu will go into a Port Trouble state. The ports on the 3845 router show idle. Cannot duplicate in testing. If you reset the ports on the PBX then they will come back up. Any ideas?

1 REPLY
Hall of Fame Super Gold

Re: PBX Ports going into a Port Trouble State

IOS on the 3845 ?

I would try upgrading and if problem still there, check/change timings on the E&M port.

105
Views
0
Helpful
1
Replies