PBX to Gateway Integration - FXS/DID VIC to FXO on PBX, Sends Digits?
We are integrating a PBX to CM through a gateway using MGCP signaling. The gateway has a 4-FXS/DID card. I noticed when I was configuring the gateway in CallManager it had a mandatory field called "attendant DN". I thought digits could be passed incoming/outgoing of the FXS ports so what would the purpose of the "attendant DN" be?
Is it just one direction digits are passed? For example, from FXO to FXS or the other direction?
I have read different things about whether FXO/FXS supported sending digits through DTMF. I am confused if I really need the attendant DN in CM, however it is a mandatory field.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...