Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Peer Firmware Sharing or Load Server in CM 5.1(3)

Someone have used some of these feature?

I'm planning an CM upgrade in a customer with 4,000 phones distributed over 140 sites and many of them have low speed links (< 512 kbps). So my ideas are:

I) Enable Peer Firmware Sharing, but I don't know if this work in CM 5.1(3), I think that this setting must be enabled before CM upgrade.

II) Load the new firmware (mainly for SIP firmwares) in gateways flash memory, and use them as 'Load Server'. But again, I think that I must enable this feature before CM upgrade.

Best Regards,

Fabio Funaki

CreatePlease login to create content