Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

people get dial tone when the call in

I get a dial tone when i call from outside the system to inside. It goes to dial tone straight away. Why has it stopped ringing? It gives the internal dial tone; if I dial my extension number that works! i need to fix this as soon as so it rings

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: people get dial tone when the call in

I am assuming you are using H323, if so then make sure you have a dial-peer with this command:

direct-inward-dial

such as:

dial-peer voice 1 pots

incoming called-number .

direct-inward-dial

port 0/0/0:23

HTH,

Chris

3 REPLIES
Hall of Fame Super Silver

Re: people get dial tone when the call in

I am assuming you are using H323, if so then make sure you have a dial-peer with this command:

direct-inward-dial

such as:

dial-peer voice 1 pots

incoming called-number .

direct-inward-dial

port 0/0/0:23

HTH,

Chris

New Member

Re: people get dial tone when the call in

Yep like an idiot id deleted the relevant dial peer. Its been a long day :(

Blue

Re: people get dial tone when the call in

That ususally indicates the call is using an inbound POTS dial peer without the direct-inward-dial command. Have you added any dial peers? Place a call and do a show call active voice brief to see what peers are being used.

Please rate helpful posts.

95
Views
0
Helpful
3
Replies