This has been asked about quite a bit but there's no feature to allow this to happen. Pretty much you are interested in the same behavior as a cell phone where if the calling party number is in your contact list or address book then the name instead of the number is displayed.
I should clarify there's no Cisco (mean Cisco supported) way to do this. The 3rd party tool that you linked to from the other thread seems to require that the contacts be maintained on a file on the server rather than using what is in the Personal Address Book (PAB) on the phone, but I could be wrong. I'm just basing this on the descritption from their website: "Associate display names to calling numbers for incoming calls. Names can be kept on text file or web server. Also allows ANI*DNIS format for T1 CAS circuits, and routing based on calling number expression."
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...