I have a phone constantly configuring ip, the por its ok, no issued with dhcp, i have tried different port, cable, i had tried the phone in a different switch and everything its ok, the mac doesnt appear in the switch throug cdp, and the show power inline shows this :
Fa2/0/11 auto on 15.4 Ieee PD 3 15.4
I had seen different issues wiht Ieee PD, i tried
shut / no shut
disabling poe and enabling it again
reconfiguring the port
plugging and unplugging the phone
Any suggestion about why this is happening and the solution?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...