Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Phone not showing in Cisco Emergency Responder

We are running Cisco emergency responder 8.5 and have a Cisco WS-C3750-48PS-S Running c3750-ipbasek9-mz.122-55.SE6.bin. Emergency responder is seeing all but one phone plugged into Fa1/0/10. The phone is also not showing up in un-located phones either. That port is configured the same as all other ports. Does anyone have any idea why a particular phone wouldn't populate ER at all? I'm not sure what else to T-shoot. CDP is enabled globally and on that interface.

CDP Information for port:

Device ID: <name removed>
Entry address(es):
  IP address: 10.100.108.67
Platform: Cisco IP Phone 7912,  Capabilities: Host Phone
Interface: FastEthernet1/0/10,  Port ID (outgoing port): Port 1
Holdtime : 172 sec

Version :
CP7912-v8-00-4-080108A

advertisement version: 2
Power drawn: 6.300 Watts
Management address(es):

CV-IDF2-375001#show run int Fa1/0/10
Building configuration...

Current configuration : 138 bytes
!
interface FastEthernet1/0/10
 switchport access vlan 18
 switchport mode access
 switchport voice vlan 108
 spanning-tree portfast
end

 

I am pending someone else move that phone to a different switch interface so I'll report back when I get some information on that.

Everyone's tags (2)
88
Views
0
Helpful
0
Replies
CreatePlease to create content