Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Phone registered with CME is not communicating with phone registered with CUCM

Hi,

I have registered one phone with CUCM and one Phone with cme and i m using one h.323 gateway between cme and cucm. But my phones cant communicate with each other. please suggest me if anything could be done on gateway to make communication between them, please find the screen shot my topology. i m making this lab in GNS3 and i have installed CUCM on vmware.

lab.jpg

Thanks and Regards,

Harish Kaushal

6 REPLIES
Cisco Employee

Phone registered with CME is not communicating with phone regist

You just need to make CME an H323 GW in CUCM and use it in a RP.

On CME create voip DPs pointing to CUCM. Make sure you bind signaling to the same IP you used in CUCM for the configuration.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Phone registered with CME is not communicating with phone regist

Hi javalenc,

Thanks for ur reply. Can't i use other router as gateway like in my topology diagram. i have configured DP's on dat.

Thanks & R's

Harish

Cisco Employee

Phone registered with CME is not communicating with phone regist

Is there no direct connectivity betweem CUCM and CME???

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Phone registered with CME is not communicating with phone regist

no um trying to use gateway between dem. R1 router is configured as gateway and i have registered dis gateway with CUCM.

Thanks & R's

Harish

Cisco Employee

Phone registered with CME is not communicating with phone regist

Then yes, if you're emulating a PSTN connection point CME to that R1 and in CUCM use a TP using that GW.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Phone registered with CME is not communicating with phone regist

thanks for ur reply.

can u please elaborate dis um not getting ur point please.

thanks and R's

Harish

238
Views
0
Helpful
6
Replies