Good afternoon, I have a big problem with the phone Cisco 7942G. In phone settings, I pointed out that I can come on the device into settings, but I can go into them, as I pointed out that I could not go through the web, but I can go through the web. In the end, what I set on the CallManager does not coincide with what it actually is.I did factory reset using keyboard shortcuts, removed completely from CallManager, changed the protocol for SIP SCCP, the same thing happens. Maybe there are some settings that I do not know. Thanks in advance. Sorry for my English
You need to check override checkbox to the right of those settings, then apply config and reset the phone for it to take hold. Without that box checked, the phone will inhereit the behavior from a higher level (e.g. common phone profile, entperise phone configuration, or product default).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.