Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pickup between PBX and CCM 6.1(2)

Hello,

i have a CCM 6.1(2) that communicates with a PBX Bosch Tenovis integral 33 via PRI/MGCP in QSIG.

I would like to know if there is a way to pickup a call of Bosch's phone from an IP phone and viceversa.

Someone have experience of this, any idea?

Thanks a lot.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Pickup between PBX and CCM 6.1(2)

Call Pickup specific to the PBX the phone is configured for. Features typically do not cross PBXs when a tie line is used such as QSIQ. The communications is typically only in/out calls, caller ID, calling headers (in the data packet of qsiq for cfwd, ring no answer, etc)

Features that are wanted do not traverse in the QSIQ trunk.

Im not even sure you could do a call pickup group between CUCM clusters.

1 REPLY

Re: Pickup between PBX and CCM 6.1(2)

Call Pickup specific to the PBX the phone is configured for. Features typically do not cross PBXs when a tie line is used such as QSIQ. The communications is typically only in/out calls, caller ID, calling headers (in the data packet of qsiq for cfwd, ring no answer, etc)

Features that are wanted do not traverse in the QSIQ trunk.

Im not even sure you could do a call pickup group between CUCM clusters.

128
Views
0
Helpful
1
Replies