Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Pilot Point with AC user

Hi,

We're running CM 4.1.2 and we're having a problem with pilot points not working in sporadic branches of the customer.Every branch uses the old style of hunt groups i.e. pilot points with AC user. Basically this customer has 200+ branches and when a typical branch receives a call, the voice gateway plar's the call to the unique branches pilot point number which then hunts through the relevant dn's of that site. However recently there have been problems when sporadic branches are not receiving calls, this is resolved by disassociating and then re-associating the pilot point with the ac user, has anyone come across this issue before, obvioulsy we're aware that we need to upgrade to the newer version of line groups but would love to know if anyone has come across this before?

Thanks alot

Paul

2 REPLIES
New Member

Re: Pilot Point with AC user

Hello Paul!

We had a similar Problem with CCM 4.0: sporadically the pilot points didn't works and the Attendant Console Clients lost the call control.

We solved the Problem with a upgrade to 4.2(3) and activating tha feature "super provider".

See this thread for more informatio about this feature:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddd4f2d

Bye,

Mirko

New Member

Re: Pilot Point with AC user

Hi Mirko,

Tks a mill for your reply, I'll check out with the customer about upgrading and activating the super provider.

Thanks

Paul

98
Views
0
Helpful
2
Replies
CreatePlease to create content