Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PLAN Implementation

I implement the PLAR using the Document ID: 47601.

It work fine for ip phones, but im having problems with fxs ports. The configuration is the same.

4 REPLIES

Re: PLAN Implementation

if u mean u want to send a call to an fxs from plar u need a pots dial peer

lets say u have fxs port 0/0/1 with number 222

diap-peer voice pots

destination-patren 222

port 0/0/1

and lets say ur fxo port is 0/1/0

do

voice-port 0/1/0

connection plar-opx 222

this way the call coming into the fxo will go directly to the fxs

IF u want the FXS to make a dirct dial when u just pick up the phone do the following on the FXS

voice-port 0/0/1

connection plar 333

call will go to number 333 but it need a

voip dial-peer to ur call manager

forexample

dial-peer voice 9 voip

destniation-patren 33.

session target ipv4:[ur CCM IP]

i am asuming u r usin H323 gateway

good luck

please, if helpful Rate

New Member

Re: PLAN Implementation

one more question, if i have configured SCCP gateway for all my 6 fxs ports in the EVM module .

Must I unconfigure the port that i need for connection plar ?.

Can I leave the fxs port controlled by the call manager via sccp and add the plar command en the voice port?.

Thanks.

Re: PLAN Implementation

i havnt worked with gateway

but as long as it is controled by the CCM try to find an optionin the port setting

or u can make the same idea as the document u have

good luck

Re: PLAN Implementation

sory i didnt mean with a gateway i meant with that gateway type u use :))

102
Views
5
Helpful
4
Replies