We have a cisco 3660 router with T1 controller and it supports the voice.
I ve configured it to use for PLAR mode it is working fine the users call my T1 number and after this they press 9 after it press the phone number of another line which they want to have their free tone on it ,now i want they skip these two steps first call 9 and after it phone number i mean they here the free tone after they immediately pick up the handset,here is the sample configuration.
yes DID is direct inward dial - you don't need that.
Now, the normal way to work is:
1st - users are authenticated before calling international. This is normally done with TCL IVR scripts, and a radius server. But if you don't want this, OK.
2nd - dialtone is given from the local(germany) router, not the remote.
Why is this, suppose that for a "test", user calls 911 - I can tell you the person that has the router in the US will be in trouble.
With the configuration I gave you, user in germany calls your router. They will hear dialtone, you can make this dialtone identical to the US one if you want. Then they dial 1+10 digits to reach any number in the US. If you want to allow to call other numbers, international, etc, you add more dial-peer with different destination-pattern. For complete information, I think the destination-pattern that I gave you before, also allows to call Canada and Carribean Islands, but that is easy to limit.
As I said before, connection plar is not necessary neither recommended for this type of application.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...