Hi everyone. I have issue with one of client request. He needs that when boss press button on the phone the call go automaticly without any number string through fxo port to another phone that directly connect to this fxo port and same with back direction when in opposite side up receiver call automaticly go to this phone through fxo port . how can i implement this funtion in call manager 8.5.
thank everybody before. This is very urgenly if you can please help to solve this issue.
CUCM does not have the trunk command/concept as CME does. CUCM is only a PBX, not a key system/hybrid system.
For outbound you will need to configure a partition, CSS and route patterns that only use that FXO port. You can then assign this CSS to that DN. This will force you to not assign a CSS to the device which breaks best practices.
The inbound direction is far easier. Either on the gateway or the analog port in CUCM (depending on protocol used) just set that FXO port to call the extension of the DN configured on that phone.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...