Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PLAR / Hotdial with IP Phones with only one DN

Hi,

I would like to know if its possible to configure a line in ip phone that if i didn't dial a number in 5 seconds an emergency number are dialed automaticaly.

I know how to configure PLAR but this didn't give me a chance to dial another number before.

Best Regards

1 REPLY
New Member

Re: PLAR / Hotdial with IP Phones with only one DN

If you want a phone to dial a specific number as soon as it goes of hook, you have to create a blank translation pattern, with the called party transformation mask as the number you want dialed. Basically how I did it was to create a special partition for this translation pattern because if you have more than one they have to be in unique partitions. Then create a specific CSS with this partition in it and all of the other neseccary partitions and apply that to the phone. When the phone goes off-hook it immediately matches that blank pattern and calls the number you specified.

Hope that helps

sdeal@netelligent.com

361
Views
0
Helpful
1
Replies