cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3045
Views
5
Helpful
3
Replies

PLAR on an MGCP controlled VG224 Gateway

deanhoy
Level 1
Level 1

Hello

Is it possible to configure PLAR on a port on a VG224 controlled gateway to call a DN? if so how would you go about configuring it.

thank you

1 Accepted Solution

Accepted Solutions

Michael Owuor
Cisco Employee
Cisco Employee

Hi Dean,

Is is possible. Here's an example of how to do it.

1. Create a partition called "Hotline".

2. Create a calling search space called "Hotline-CSS".

3. Move the partition "Hotline" into the "Hotline-CSS" calling search space.

4. Create a translation pattern. Leave the pattern itself blank, select "Hotline" as partition, and specify a calling search space that contains the number that the PLAR phone needs to dial. Enter the destination number in the "Called Party Transformation Mask" field.

5. From the configuration page of the gateway, select the port connected to the analog phone that will serve as a PLAR phone.

6. Set the "Calling Search Space" field to "Hotline-CSS" for this port.

7. Reset the MGCP member.

I hope this helps.

Regards,

Michael.

View solution in original post

3 Replies 3

Michael Owuor
Cisco Employee
Cisco Employee

Hi Dean,

Is is possible. Here's an example of how to do it.

1. Create a partition called "Hotline".

2. Create a calling search space called "Hotline-CSS".

3. Move the partition "Hotline" into the "Hotline-CSS" calling search space.

4. Create a translation pattern. Leave the pattern itself blank, select "Hotline" as partition, and specify a calling search space that contains the number that the PLAR phone needs to dial. Enter the destination number in the "Called Party Transformation Mask" field.

5. From the configuration page of the gateway, select the port connected to the analog phone that will serve as a PLAR phone.

6. Set the "Calling Search Space" field to "Hotline-CSS" for this port.

7. Reset the MGCP member.

I hope this helps.

Regards,

Michael.

thank you for the reply. I will try this and update you.

Regard

Dean.

also note -  (as this is confusing)  You do NOT put an DN on the extension.  You go to the port, add the CSS.  No DN is needed. 

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: