Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PLAR on an MGCP controlled VG224 Gateway

Hello

Is it possible to configure PLAR on a port on a VG224 controlled gateway to call a DN? if so how would you go about configuring it.

thank you

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: PLAR on an MGCP controlled VG224 Gateway

Hi Dean,

Is is possible. Here's an example of how to do it.

1. Create a partition called "Hotline".

2. Create a calling search space called "Hotline-CSS".

3. Move the partition "Hotline" into the "Hotline-CSS" calling search space.

4. Create a translation pattern. Leave the pattern itself blank, select "Hotline" as partition, and specify a calling search space that contains the number that the PLAR phone needs to dial. Enter the destination number in the "Called Party Transformation Mask" field.

5. From the configuration page of the gateway, select the port connected to the analog phone that will serve as a PLAR phone.

6. Set the "Calling Search Space" field to "Hotline-CSS" for this port.

7. Reset the MGCP member.

I hope this helps.

Regards,

Michael.

3 REPLIES
Cisco Employee

Re: PLAR on an MGCP controlled VG224 Gateway

Hi Dean,

Is is possible. Here's an example of how to do it.

1. Create a partition called "Hotline".

2. Create a calling search space called "Hotline-CSS".

3. Move the partition "Hotline" into the "Hotline-CSS" calling search space.

4. Create a translation pattern. Leave the pattern itself blank, select "Hotline" as partition, and specify a calling search space that contains the number that the PLAR phone needs to dial. Enter the destination number in the "Called Party Transformation Mask" field.

5. From the configuration page of the gateway, select the port connected to the analog phone that will serve as a PLAR phone.

6. Set the "Calling Search Space" field to "Hotline-CSS" for this port.

7. Reset the MGCP member.

I hope this helps.

Regards,

Michael.

New Member

Re: PLAR on an MGCP controlled VG224 Gateway

thank you for the reply. I will try this and update you.

Regard

Dean.

New Member

also note -  (as this is

also note -  (as this is confusing)  You do NOT put an DN on the extension.  You go to the port, add the CSS.  No DN is needed. 

 

1498
Views
5
Helpful
3
Replies