10-27-2009 01:18 AM - edited 03-15-2019 08:14 PM
Hello, im quite new to voip world, so i have a rewarding and challenging
Job, there is my question.
I manage a little network, we have a few PSTN lines to our GW, some of these lines are "fowarded" to IP extensions within the network using PLAR but i cant get the caller number to be displayed in the ip phone
Any suggestions?
Thanks in advance
Cesar
10-27-2009 01:37 AM
Hola Cesar,
First question is if you connect an analog phone do you recieve Caller ID from Telco?
Then enable caller id in voice ports by using caller-id enable command
http://www.cisco.com/en/US/docs/ios/12_3t/voice/command/reference/vrht_c4.html#wp1059594
Then you can post your config and run some debugs:
debug voice ccapi ino
debug vpm signal
10-27-2009 02:48 AM
Ok, I was supposing that i was receiving the information from telco but it was not right, thanks a lot for your help.
Cesar
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide