Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Please help! Need advice on configuring dial-peers.

We have a CME at one location (Location A) that has a PRI to the PSTN. At another location (Location B) we have a Cisco voice gateway that has a PRI connection to a PBX.

I can successfully call from the CME to the PBX however when a user on the PBX calls an extension on the CME they get a dialtone, then if they dial the extension again the call goes thru. What an I doing wrong????

Topology:PSTN<--PRI-->CME (site A)<--WAN-->Cisco gateway(Site B)<--PRI-->PBX

Location A Extension Range: 10xx

Location B Extension Range: 88xx

-------Location A Dial Peers------

dial-peer voice 1 pots

description ** PRI to PSTN

translation-profile outgoing CallerID

destination-pattern 9T

port 0/0/0:23

forward-digits all

!

dial-peer voice 100 voip

description ** 4 Digit Calls to Location B

destination-pattern 88..

session protocol sipv2

session target ipv4:10.10.100.1

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

dial-peer voice 101 voip

description --> Incoming VoIP Calls From Location B

session protocol sipv2

session target ipv4:10.10.100.1

incoming called-number .

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

-------Location B dial peers-------

dial-peer voice 1 pots

description ** 4 Digit Calls to Location B PBX

destination-pattern 88..

incoming called-number .

port 0/3/0:15

forward-digits 4

!

dial-peer voice 100 voip

description ** 4 Digit Calls to Location A

destination-pattern 10..

session protocol sipv2

session target ipv4:10.10.100.1

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

dial-peer voice 101 voip

description ** Incoming VoIP Calls From Location A

session protocol sipv2

session target ipv4:10.10.200.1

incoming called-number .

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Please help! Need advice on configuring dial-peers.

Hi,

configure "direct-inward-dial" and add "incoming called-number xx.." to your DP 100.

Hope this helps, please rate post if it does!

2 REPLIES
Hall of Fame Super Gold

Re: Please help! Need advice on configuring dial-peers.

Hi,

configure "direct-inward-dial" and add "incoming called-number xx.." to your DP 100.

Hope this helps, please rate post if it does!

New Member

Re: Please help! Need advice on configuring dial-peers.

Thanks. That was the issue. I needed direct inward dial on the pots dial peer.

103
Views
0
Helpful
2
Replies
CreatePlease to create content