I have bought a Cisco IP Conference Station 7937G and its specific PoE injector "Cisco power splitter CP-7937-PWR-SPL". The Phone powers-up but it does not connect to the Ethernet line. It says that the network connection is not active. Effectively, in the UC520 router (or any other switch I tried in the network) there is no active LED corresponding to the cable coming from the 7937. I have configurate it to work in DHCP mode, and I have inserted a Network Protocol Analyzer to show some traffic. The phone sends nothing, and at least it should send an ARP request for a DHCP server. Furthermore, even that the PoE injector has a standard 8 pin RJ45 connector, the 7937 has a 10 pin RJ50 connector, physically compatible with the RJ45 (of course without connecting the two outer pins). That sounds strange...Does anybody know if I need a special cable? Does anybody have the diagram of such a cable?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4