Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

port monitoring or SPAN on UC520

Is there a way to do this? The "monitor session" and "port monitor" commands aren't available on a UC520 running IOS 12.4(11)XW.

Thanks,

Diego

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Gold

Re: port monitoring or SPAN on UC520

No. The switch on UC520 is a "dumb" one.

Re: port monitoring or SPAN on UC520

Hi Diego,

I just tested XW and XW6 and they both have the command on the router by default. I'm not sure what you may have configured on your router to prevent this. You are looking in global config mode right?

-nick

8 REPLIES
Hall of Fame Super Gold

Re: port monitoring or SPAN on UC520

No. The switch on UC520 is a "dumb" one.

New Member

Re: port monitoring or SPAN on UC520

Thank you sir. I guess I can't stop searching now.

Diego

Re: port monitoring or SPAN on UC520

Hi Diego,

You can do this - I just checked on my UC520 here in the lab on 12.4(20)T. I believe the functionality existed before, but don't have a UC520 on 12.4(11)XW to confirm.

Also - on the CE520, you can also run it.

Go to: http://192.168.1.1/exec/

From there you can 'conf t' and configure it via CLI, like any other IOS switch. It has reduced capabilities, but it can still SPAN.

hth,

nick

New Member

Re: port monitoring or SPAN on UC520

Hi Nick,

Not sure what you are suggesting. I know how to get to the CLI. What I am looking for are the commands needed to turn on SPAN. It doesn't look like the UC520 hardware/software support them.

Thanks,

Diego

Hall of Fame Super Gold

Re: port monitoring or SPAN on UC520

What Nick is saying, he can enter span commands with a newer IOS.

I'm also surprised by that, but it's something certainly worth a try.

New Member

Re: port monitoring or SPAN on UC520

OK, I'm game. I will look for an upgrade and try again.

Thanks,

Diego

Re: port monitoring or SPAN on UC520

Hi Diego,

I just tested XW and XW6 and they both have the command on the router by default. I'm not sure what you may have configured on your router to prevent this. You are looking in global config mode right?

-nick

New Member

Re: port monitoring or SPAN on UC520

yes, you are right, the commands are there. Not sure what I was doing that I didn't see them before.

Thank you very much.

Diego

461
Views
0
Helpful
8
Replies