Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port not available to be added to route group

CUCM 9.1.2

I have a 2911 (MGCP) with an FXO card.  The FXO port is configured and shows as registered but will not show up in the ports list in my route groups so that I can add it.  Every other port from my other MGCP gateways shows up fine.  Resetting the port and having it re-register did not help.  Any ideas?

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions

If the port is assigned to a

If the port is assigned to a route pattern, it wont be an option available under Route groups and vice versa. I would check depending records on the ports to see where its assigned and change it.

Please rate useful posts.
2 REPLIES

If the port is assigned to a

If the port is assigned to a route pattern, it wont be an option available under Route groups and vice versa. I would check depending records on the ports to see where its assigned and change it.

Please rate useful posts.
New Member

That was it.  There was a

That was it.  There was a pattern pointing directly at the port.  As soon as I changed the pattern to point to a RL instead, the port showed up in the RG list.  Thanks.  

103
Views
0
Helpful
2
Replies
CreatePlease login to create content