Port on VIC2-2FXS generates CLID tone; how to disable?
I have an analog phone connected to this card. The card is located in a 2821 router registered into call manager.
When a call is presented to the analog port and I answer, a fax like tone is generated for 1 second. I think it may be the card sending a CLID tone to the phone to display it. Do you know how to disable this?
I was expecting a parameter to be present in the voice-port configuration.
Re: Port on VIC2-2FXS generates CLID tone; how to disable?
Most likely is not clid that you are hearing, but an echo canceller disable (guard tone). These are tones are used by modem and fax to disable echo cancellers that may be present in the circuit. Is there something in the CM configuration that relates the port to fax ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...