I am trying to setup a VG224 to replace the large bank of ATAs I have collected for faxing. When I do a sho ccm I see the VG224 is registered. Looking in UCM 6 I see the individual ports showing Registration Rejected.
Here is the config I am running:
chvg224#sho run | b mgcp
ccm-manager config server 10.4.1.10
mgcp call-agent 10.4.1.10 service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode out-of-band
mgcp rtp unreachable timeout 1000 action notify
mgcp modem passthrough voip mode nse
mgcp package-capability rtp-package
mgcp package-capability sst-package
no mgcp package-capability res-package
no mgcp package-capability fxr-package
no mgcp timer receive-rtcp
mgcp sdp simple
mgcp fax t38 inhibit
mgcp rtp payload-type g726r16 static
mgcp bind control source-interface FastEthernet0/0
Re: Port registration rejected on VG224 using MGCP
Make sure the device you set up in Call Manager is called "chvg224" or, if you have a domain name in your router config, "chvg224.yourdomain.com". Though, by your symptoms, it looks like you got that far already.
Also, to have your dial peers created automatically, you may add "ccm-manager config", otherwise create them manually and add the "service mgcpapp" command under each one.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...