Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

POS machine transmit slowly through VG202

Dears,

Recently we deployed IPT for our customer to replace the traditional PBX system. Everything is ok except the POS machine behind the VG202. We find that the POS machine transmits slowly than in the PBX system. We use sccp between CM7.0 and VG202, MGCP between C3825 and CM, fax and other analog phones work well on the same VG. Modem relay has been enabled on the VG, anything else I missed?

Any suggestion?

Thanks,

Kirin

6 REPLIES
Hall of Fame Super Gold

Re: POS machine transmit slowly through VG202

Do you have PRI ?

New Member

Re: POS machine transmit slowly through VG202

Yes,we do

Hall of Fame Super Gold

Re: POS machine transmit slowly through VG202

Send "show controllers E1" and "show network-clocks" on the router with PRI.

New Member

Re: POS machine transmit slowly through VG202

Hi bevilacqua,

Thanks for your reply. Do you think it's the slip problem? I am sure there is no slip error on the PRI line.

Hall of Fame Super Gold

Re: POS machine transmit slowly through VG202

If no slips, then PRI is not the problem.

New Member

Re: POS machine transmit slowly through VG202

I think so.

Maybe the Modem Relay cause the delay? So is that better for me to change the method from modem relay to modem pass-through for POS data transmission?

Thanks,

Kirin

305
Views
0
Helpful
6
Replies
CreatePlease login to create content